JG West Classrooms Quick Start Guide V2

Owned by Former user (Deleted)
Last updated: Mar 10, 2022
2 min read

This guide is intended for faculty and staff that use the JG West Classrooms.

Using the Built-in PC

  1. Select the PC/Podium button on the screen next to SELECT SOURCE, located at the top. This will also turn on all projectors (may take up to 60 seconds to fully warm-up) and adjust the lights  to presentation mode.

  2. Log-in with your UNI username and password. Or, you can log-in with:

    1. Username: .\av-guest

    2. Password: 11aa22bb$$

Don’t See A Screen?

There is a gray remote (either on top of the podium or in the drawers). Press the up button to raise the screen. To wake up the screen, touch the screen for 1-2 seconds.

Using the Lavalier Microphone

  1. To use the Lavalier, there is an on/off switch located on the top of the Lavalier. The light will turn green when the Lavalier is on.

  2. Clip the Microphone 2-3 inches below your chin, with the microphone pointing up.

  3. To adjust the volume, select the Green Volume Control on the screen. 
    1. “Speech”  controls the microphones, “Program” controls the Laptop/PC volume. If you select mute, it will stop all audio.

Lavalier Microphone Needs A New Battery

Replacement of AA batteries are located in the right side drawer of the podium.

Using the Projector

  • To turn on the projectors, select  PC Podium next to SELECT SOURCE, located at the top. The projectors may take up to 60 seconds to fully warm-up.
  • To temporarily hide the screen from the audience, select the Green Hide Projection.
  • To temporarily raise the screen to use the blackboard, select the Blue Projector Power. Touch the up/down arrow to raise/lower the screen. You can also turn on/off the projector from here.

Using the Laptop/Tablet with a Wired Connection

  1. Connect your laptop to the provided VGA, HDMI, USB-B, USB-C and power outlets.
  2. Next to SELECT SOURCE click on Laptop.

Using A Laptop/Tablet Wirelessly

  1. Next to SELECT SOURCE click on AirMedia.
  2. You will see the AirMedia Splash page. On the bottom left of the screen, there is an IP address and a code. Enter the IP address into your internet browser and follow the instructions provided.


Related articles