/
Quick Start Set-Up Guide for WJ L107

Quick Start Set-Up Guide for WJ L107

Owned by Brian Wallen
Jan 16, 2025
4 min read

Introduction

This article will provide instructions on how to set up the classroom’s technology for teaching.

Turning on the PC

To raise the touch screen monitor, locate the silver remote inside the drawer of the podium and tap the UP arrow once, you should hear the lift start moving and the monitor will raise fully.

  1. To wake up the monitor, press the monitor for 1-2 seconds and you should see the PC.

  2. If you still see a black screen, open up the podium doors located below the drawers (as shown below).

IMG_0078.jpg

 

  1. Make sure the PC computer inside the podium is ON. The power button will emit a white light if so. If there is no light, press the power button to turn on the PC. The computer will be visible on both projector screens as well as the monitor on top of the podium

ConfluencePC.jpg

 

Signing into the Computer

If the computer is already on and logged into the desktop, you can proceed with accessing and displaying your material.

  1. Using the keyboard, press ENTER twice to advance to the signage page. Use the mouse to select Other User.

  2. Sign into the PC using your UNI (excluding the @columbia.edu) and password (like shown below).

  3. Once signed in successfully, you will be taken to the desktop as shown below.

Setting up Projection

  1. You can either use the wall panel or the monitor on the podium to press the PC button. This will turn on the projector, lower the screen and display the PC screen.

 

Setting up Microphone

There are two options available for projecting your voice in the room:

Using the Lavaliere Microphone

  1. There is a lavaliere microphone located on top of the podium. This can be used to project your voice while walking around the room.

If you don’t see the lavaliere microphone, check the podium drawers.

 

Clip the microphone on about 6 inches away from your mouth. Place the power switch located at the top of the mic to the On position. The green light will indicate the power is on. Speak then adjust the height of the microphone accordingly to reach your desired volume.

 

Using the Handheld Microphone

  1. Locate the handheld microphone on top of the podium.

  2. Turn on the power switch. The mic window will be lit indicating the power is on.

  3. Speak and adjust the microphone position as needed for desired volume.

 

Troubleshooting

Issue

Solution

Monitor is missing

To elevate the touch screen monitor, find the silver remote in the podium drawer. Press the UP arrow once. You will hear the lift in motion, raising the monitor completely.

Login issues

Double-check UNI and password; contact AV if the issue persists.

Projector not displaying

Verify "PC" button was pressed on wall panel or podium monitor.

Microphone does not turn on

Change the batteries. Batteries can be found in the podium drawer.

 

 

If you run into any issues, please contact Columbia Law AV at 212-854-2400 or email avrequest@law.columbia.edu.